User's Manual

32
Garage Door Opener Parts
DESCRIPTION
NOT SHOWN
Troubleshooting
Diagnostic Chart
DIAGNOST
IC CODE
T
HE
LIGH
T
SYMPTOM CAUSE RESOLUTION
2 flash
The opener do not
automatically open the
door and close the door
Manually open and close the door. Check
for binding or obstructions, reprogram the
travel, refer to
p
a
g
e 30.
3 flash The opener do not runs Bad logic control board
Replace the logic control board.
4 flash
The garage door opener
will not close and the
light(s) flash.
Safety sensors are not
installed,connected,or
Wires may be cut.
Inspect sensor wires for a disconnected or
cut wire(s). If the sending sensor
with the RED LED is NOT lit, check the
wire and connections for that sensor.
If sending sensor LED is lit, check the
wire connections leading to the receiving
sensor (green LED). Reattach wire or
replace wire as needed. If
pre-wired home, check the splices. See
page 24 for installation. Close the garage
door using the remote control or the door
control.
5 flash
Door is closing,stops
and reverses
Obstruction,binding or
sticking door
If your door is binding or sticking, contact
a trained door systems technician。If
your door is okay, reprogram the travel,
refer to
p
a
g
e 28.
6 flash
The openers runs
approximately 8-12mm
and stops
Communication error
to travel module
Disconnect all power, remove cover, and
locate the travel module. Ensure the wires
for travel module are connected, if wires
are connected, then replace the travel
module.
1. Chassis.
2. Motor and Hall sensor
3.
Transformer
4. Logic Control Board
5.Light Lens(Model 9357·Model9367)
6.Light Socket
7. Light socket fixed board
8. End panel with light socket
9. End panel with Logic Control Board
10. Cover (Model 9357·Model9367)
11.Wiring Board
12.Strain relief
13.Power Cord
1
Wire Harness Kit
Hall sensor
2
3
4
5
6
7
8
9
10
11
12
13