User's Manual

Hanging the garage door opener will vary depending on your garage. Below are three example installations. Your

installation may be different. For ALL installations the garage door opener MUST be connected to structural supports. The

instructions illustrate one of the examples below.

HARDWARE

6、Install the light bulbs

CAUTION

To prevent possible OVERHEATING of the end panel or light socket:

· Use ONLY A19 incandescent or compact ﬂuorescent light bulbs.

· DO NOT use incandescent bulbs larger than 100W.

· DO NOT use compact ﬂuorescent light bulbs larger than 26W (100W)equivalent.

· DO NOT use halogen bulbs.

· DO NOT use short neck or s

ecialt

ht bulbs.

ili

5.1On ﬁnished ceilings, use the lag

screws (H7) to attach a support

bracket (not provided) to the

structural supports before installing

the garage door opener

5.2 Make sure the garage door opener

is aligned with the header bracket.

Measure the distance from each

side of the garage door opener to

the support bracket.

5.3 Cut both pieces of the hanging

racket to re

uired len

ths.

Not

rovide

5.4 Attach the end of each hanging

aligned bracket to the support bracket

with appropriate hardware (not

provided).

5.5 Attach the garage door opener to

the hanging brackets with the bolts

(H15), lock washers (H21) and nuts

(H20).

5.6 Remove the 2x4 and manually close

the door. If the door hits the rail,

raise the header bracket.

Not

rovide

H4 Hex Bolt M8×20(2) H3 Hex