User's Manual

WARNING

If the straight door arm is hanging down too far, you may cut 6 inches (15 cm) from the solid end.

Install the Wall Control

1 Install the wall control

To prevent possible SERIOUS INJURY or DEATH from electrocution:

· Be sure power is NOT connected BEFORE installing door control.

· Connect ONLY to 24 VOLT low voltage wires.

To prevent possible SERIOUS INJURY or DEATH from a closing garage door:

· Install door control within sight of garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and

away from ALL moving parts of door.

· NEVER permit children to operate or play with door control push buttons or remote control transmitters.

· Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no

obstructions to door travel.

ALWAYS k

d i i ht til l t l l d NEVER it t th f l i

9.3 Attach the curved door arm to he door

bracket using the clevis pin (H13). Attach

with the ring fastener (H19).

9.4 Bring arm sections together. Find two pairs of

holes that line up and join sections. Select holes as far

apart as possible to increase door arm rigidity and

attach using the bolts (H15), nuts (H20) and lock

washers (H21).

9.5 Pull the emergency release handle toward

the garage door opener until the trolley

release arm is horizontal. The trolley will

re-engage automatically when the garage

door opener is activated.