User Guide

Synchronized Chuff pickup installation
with original equipment Hall Effect sensor
Some steam locomotives are equipped with a round magnet mounted on an axle with a sensor to read
the rotation of the magnet. The drawings below are for use with the original equipped Lionel® hall effect
sensor. While modifications to the main board are shown, they do void warranty.
LocoMatic™ Type 3 Sound & Control System synchronization wiring
246 W. Main St.
Leola, PA 17540
[phone]
w
w
w
.
d
a
l
l
e
e
.
c
o
m
LocoMatic™ Type 4 Sound & Control System synchronization wiring
Long edge of Locomatic™
Control Board
SYNC input
see page 7 of main
instruction sheet
for full details.
RED
GREEN
BLACK
GREEN
BLUE
YELLOW
Sensor wires from
Lionel® pcbd.
For the Hall Effect sensor to operate best, short R22.This must be
done with a small pencil soldering iron and great care as to not
damage the board. You can try it's operation first without doing
this but it may be necessary to do so.
SYNC input
see page 7 of main
instruction sheet
for full details.
RED
WHITE
BLACK
GREEN
BLUE
YELLOW
Sensor wires from
Lionel® pcbd.
For the Hall Effect sensor to operate best, short R25.This must be done with a
small pencil soldering iron and great care as to not damage the board. You
can try it's operation first without doing this but it may be necessary to do so.