User`s manual

Pantera TF 1M60 and 1M30 User’s Manual Preliminary 15
DALSA 03-32-10033-08
Visit the www.dalsa.com Web site for a list of companies that make power supplies that
meet the camera’s requirements. The companies listed should not be considered the only
choices.
2.5 Control Inputs
The camera accepts an EXSYNC control input through the Camera Link MDR26F
connector. External control signals are optional and enabled through the serial interface.
EXSYNC (Triggers Line Readout)
EXSYNC is an optional input signal that can be used to trigger the line readout rate.
Depending on the camera’s exposure mode setting, it can use either the rising or falling
edge of EXSYNC to trigger line readout. Refer to the following table for details.
Table 6: EXSYNC Edge Description
Mode EXSYNC Edge Description
4 The rising edge of EXSYNC begins camera integration. The falling edge
completes integration.
3 The falling edges of EXSYNC define the frame time.
6 The falling edge of EXSYNC initiates camera integration.
For more information on camera exposure modes, including timing diagrams, refer to
section 3.7 Setting Frame Rate, Exposure Time, and Exposure Mode on page 20.
NOTE: EXSYNC should not be clocked faster than the camera’s specified maximum frame
rate. The camera ignores the EXSYNC pulse until it has completed reading the last line
out.