User`s manual

56 Preliminary Pantera TF 1M60 and 1M30 User’s Manual
DALSA 03-32-10033-08
Command Syntax Parameters Description
set binning
mode
sbm i i
Set the camera’s binning mode. The first
value sets the horizontal binning. The second
value sets the vertical binning. Available
modes are:
1x1, 2x1, 4x1, 8x1,
1x2, 2x2, 4x2, 8x2,
1x4, 2x4, 4x4, 8x4,
1x8, 2x8, 4x8, 8x8.
The factory setting value is 1x1. .
set exposure
control
sec i
Enables or disables exposure control. Only
applicable if you are operating in exposure
mode 3. Available values are:
0: Exposure control disabled resulting in a
frame rate of 60fps for 1M60 or 30fps for
1M30
1: Exposure control enabled resulting in a
frame rate of 57fps for 1M60 or 27fps for
1M30
set exposure
mode
sem i
Set the exposure mode. Available values are:
2: Internal SYNC and PRIN, programmable
frame rate and exposure time using
commands ssf and set
3: External SYNC, internal PRIN, maximum
exposure time
4: Smart EXSYNC
6: External SYNC, internal PRIN,
programmable exposure time
7: (Factory Setting) Internal programmable
SYNC, maximum exposure time.
set exposure
time
set f
Set the exposure time in exposure mode 2 or
6. Value will be a floating point number in
µsecs.
set output
mode
sos i
Sets whether to read out data using one or
two taps. Only applicable to the 1M60.
set pretrigger
sp i
Set the pretrigger to a value from 0 or 15
set sync
frequency
ssf f
Sets the frame rate in modes 2 and 6.
set system gain
ssg t i
The first value is the tap value. Either 1 for
the left tap or 2 (1M60 only) for the right tap.
The second value is the analog gain with an
available range from 0-4095.
Parameters:
i = integer
f = float
t = tap