Installation manual

Version 02 teledynedalsa.com/ipd 17
When the application is set up and stored on the camera, the Ethernet connection can
be disconnected and the inspection will run autonomously (if power is supplied on the
IO connector).
The camera can easily store over 50 inspection programs in its flash storage memory.
These programs can be switched through network commands, or through established
PLC register connections or through the iNspect application interface.
The camera administrator can setup user accounts with various levels of access
privilege. With password control enabled, the web server will prompt users for a valid
login and the application will only expose controls associated with that account.
Firmware Upgrading
Note: Export your saved inspection program files before upgrading the firmware.
BOA firmware may need to be updated occasionally to add new features or fix reported
problems. To do this, click on “Firmware” then select “Update Firmware”. To upgrade,
simply browse to the location of the upgrade binary file “update.pak” (obtain from your
Teledyne DALSA representative) on the connected PC and click the upgrade button.
After a firmware upgrade, it is recommended that the programming PC be upgraded to
a version of the Client software that matches the new firmware version. The new Client
software should be obtained at the same time as the firmware update file. The two
software packages are build together, and should have the same date and time.
Uninstall the current version of the Sherlock Embedded Client, using the Windows “Add
and Remove Programs”. Reboot the PC, and install the newer version that matches the
firmware you just installed.