User`s manual

iNspect Express User’s Manual405-00026-00
95Rev 1600; 12 July 2010
NOTE When you click the Reset Inspection button on the Monitor panel, you must tell
the BOA vision system how many parts there are between the Inspection Trigger
and the Rejection mechanism. These parts are “Passed” by the iNspect soft-
ware.
If you are not using the output delay (BOA Outputs) then your PLC should have a similar system
for dealing with parts in the pipeline.
The Pass/Recycle/Reject light is latched after a decision, and stays latched until the next decision
is available.
Edit Tolerances
Click on “Edit Tolerances” in the Control and Navigation panel. The Configuration and Status
panel changes to a scrollable table. You can change tolerance values or “pivot points” in this
table. Changes here also affect the values in the tool properties windows.
NOTE There is no undo button. Changes take effect as soon as you enter a number and
click outside the number field.
Save your Solution before making changes. You can reload the Solution to undo Tolerance
changes.
• If you save your Solution after making changes, the changes become permanent.
• If you do NOT save the Solution after making changes, the original values are restored the next
time you load the Solution.
Changing Measurement Tolerances