User`s manual

405-00026-00iNspect Express User’s Manual
104 Rev 1600; 12 July 2010
HyperTerminal
You can use HyperTerminal for either Ethernet or Serial communication, if your Vision System
is configured for data output.
a. Open a new HyperTerminal session, enter your area code, and click “Ok”.
b. In “Connection Description” enter a name for the session, for example, “iNspect1”.
c. For Ethernet: Enter the IP Address of the Vision System in the “Host Address” and enter the
port number (BOA default is 5020). Select “TCP/IP(Winsock)” for the “Connect using”.
For Serial Port: Select COM1 or COM2 (your PC serial port) for the “Connect using”.
Change the Port Settings to match the values you set in the Add/Edit Destinations panel.
Note: In some versions of HyperTerminal, you can enter all information in the “Connect
To” menu. In some versions, you will have to open the File–Properties menu.
d. Click “Ok”, and the data should immediately start scrolling in the HyperTerminal window.
If not, double-check your port settings in HyperTerminal. If there is still no data, verify that a
Solution is active and running, and conditional output is enabled in the Setup Outputs panel.