User`s manual

iNspect Express User’s Manual405-00026-00
109Rev 1600; 12 July 2010
NOTE The Position anchor alone can track or follow horizontal and vertical move-
ment, but not rotation. If your part is mechanically restricted to not rotate, for
example a square or rectangle part sliding between two closely fitting rails, the
position anchor alone may be enough. If your part does rotate, you need a Rota-
tion anchor too.
7. In the Configuration and Status panel, select Rotation anchor. Click on the center point of
the second Match tool (MS2). A flag icon appears on the point.
Rotation Anchor
Position Anchor
Locator Anchors On 2 Match Tools
With two anchors, the Locator can track or follow movement and rotation.
The default settings of the Match Tool compensates for small rotation. The match score may
drop, and Match Tool may flag a recycle or fail, if the part rotates too much. You can adjust the
rotation limits in the match tool Properties box.