User`s manual

iNspect Express User’s Manual405-00026-00
111Rev 1600; 12 July 2010
3. Hover your cursor over the first line. Drag the square handle at the end of the line, to extend
the first pencil line past the end of the part.
Extending the Pencil Line
4. Hover your cursor over the second line. Drag the square handle at the end of the line, to
extend the second pencil line past the end of the part, to intersect with the first pencil line.
An active point is created where the two lines meet (intersect).
Both Lines Extended to Create an Intersection Point
5. Hover over the first click point, and extend the size of the search area to compensate for the
largest expected movement of the part. Repeat for the second click point on this line.
Increasing the Search Area
NOTE The Point search area only compensates for movement perpendicular to the
line. In this illustration, the Pencil line is horizontal, and the search area com-
pensates for vertical movement of the part, not horizontal movement.