User`s manual

iNspect Express User’s Manual405-00026-00
115Rev 1600; 12 July 2010
5. Click on one of the points on the Edge Count region. A cross hair appears with a label
“Loc1”.
6. In the Configuration and Status panel, select “Rotation anchor”
7. Click on a second point on the Edge Count region, the furthest point from the position an-
chor is best. The flag icon should appear.
Edge Count and Locator Anchors
Cascading Locators
If the notched disk in the “Edge Count Tool – Circle” example were not mounted on a shaft, and
could move around in the image area, the Edge Count tools would have a very difficult time find-
ing the notch. We can use one locator to accurately place a tool for another locator.
1. Create a Match tool on the white circle in the center of the disk.
2. Expand the search area (green rectangle in the illustration) to compensate for movement of
the center.
3. Open the Match Tool Properties, and activate the center point of the Match tool.
Notched Disk with Match Tool