User`s manual

iNspect Express User’s Manual405-00026-00
13Rev 1600; 12 July 2010
As you define measurement tools in the image area, the tools appear in the Tool List, in the Con-
figuration and Status panel.
Tools List
Best Practice Suggestion
a. Perform Calibration first (page 7), before defining any tools. If you try to perform calibra-
tion after defining tools, all tools will be deleted.
b. Create just the tools that will be used for your Locator.
c. Define the Locator or Locators (page 79).
d. If you are using X,Y coordinates (for positioning or robot guidance) place the Axis Origin
(page 82).
e. Create the rest of your measurement tools. Attach them to the locator (or locators).
Using Edge Sensitivity
You cannot adjust the edge sensitivity if you have an intensity-based tool selected (Count, Inten-
sity, Match). You must select an edge-based tool.
a. Move your cursor into the image area, and hover the cursor on any highlighted edge.
b. Right-click on an edge. All detected edges are highlighted, and the Edge Sensitivity opens.
Edge Sensitivity
c. Use the slider and arrow keys to adjust the edge sensitivity from 0% to 100%.