User`s manual

iNspect Express User’s Manual405-00026-00
19Rev 1600; 12 July 2010
NOTE If you enter new units, and select “Coordinate System”, clicking the green
“check” in the scale properties immediately applies the changes to the whole
coordinate system; the red X button in the Distance Properties does not undo the
change to the coordinate system. Click the curved arrow button
to undo
scale changes, and revert to pixel coordinates for the whole coordinate system.
This removes Calibration.
Scale Properties
g. Click on the “check” button to accept changes and close the Scale box. Click on the red
X button
to close without changes. Click the arrow button to undo scale and calibration.
h. In the Distance Properties box, click on the padlock
button to lock the value for “Per-
fect” to keep it from changing if you move or adjust your measurement.
i. Click the “Preprocess” button
to add image filtering, or feature enhancement. Adding
preprocessing may increase inspection time. Please refer to page 15.
j. Click on the “check” button
to accept changes and close the Distance Properties box.
Click on the X button
to close without changes.