User`s manual

iNspect Express User’s Manual405-00026-00
21Rev 1600; 12 July 2010
Angle Properties
Angle the angle formed by two edges.
• Enable – check this box to report a measurement and pass or fail the part on this measurement;
or clear this box to not report a measurement and not pass or fail the part on this measurement.
• Relative – clear the box to report actual numbers; check the box to report difference.
• Auto label position – puts the label (A1, A2) beside the curve in the display. Clear the check
box to move the label to another location (or with the Properties box closed, drag the label).
• Locator – makes the tool follow the Locator, and follow the part. Select a locator (by number)
to follow, or select “X” to disconnect the tool from the locator, or make the tool stay in a fixed
position in the image area.
• Show corner point – allows you to use the corner point as a Point in measurements.
• Accuracy – number of sampling points to find the edges at the end points, indicated by the pink
dots.
f.
Click on the padlock button to lock the value for “Perfect” to keep it from changing if
you move or adjust your measurement.
g. Click the “Preprocess” button
to add image filtering, or feature enhancement. Adding
preprocessing may increase inspection time. Please refer to page 15.
h. Click on the “check” button
to accept changes and close the Angle Properties box.
Click on the X button
to close without changes.