User`s manual

iNspect Express User’s Manual405-00026-00
29Rev 1600; 12 July 2010
• Auto label position – puts the label (CC1, CC2) beside the circle in the display. Clear the check
box to move the label to another location (or with the Properties box closed, drag the label).
• Locator – makes the tool follow the Locator, and follow the part. Select a locator (by number)
to follow, or select “X” to disconnect the tool from the locator, or make the tool stay in a fixed
position in the image area.
• Show center point – displays the point at the averaged center, and allows you to use it in other
measurements.
e.
Click on the padlock button to lock the value for “Perfect” so it does not change as you
adjust or move your measurement.
f. Click the “Preprocess” button
to add image filtering, or feature enhancement. Adding
preprocessing may increase inspection time. Please refer to page 15.
g. Click on the “check” button
to accept changes and close the Concentricity Properties
box. Click on the X button
to close without changes.
Using the Edge Count Tool
The Edge Count tool counts the number of edges crossed by a line, or the outline of
the Region. This tool is sensitive to changes in light conditions.
a. Click on the “Edge Count” button. Select the Region shape. Refer to the Tip window for
drawing suggestions.
b. Move the mouse over the image in the Work
Area. There should not be any highlighted
edges. Click, release, move the mouse and
click again, to draw the Region where you want
to count the edges. The Region is labeled (E1,
E2, etc.). Small pink dots show the edges de-
tected.
c. When the Edge Count tool is selected, you can move and resize the Region.
d. When you hover the cursor over the edge of the Region, the Region and label turn red, and a
message appears telling you to “Right-click to edit.”
e. Right-click on the Region. An Edge Count Properties box opens. In this box you can select
the different inspection tabs to enable, rename, set the tolerances for recycle and reject,
change the edge sensitivity. Use the tabs and “Enable” check boxes to select measurements.