User`s manual

resize
405-00026-00iNspect Express User’s Manual
36 Rev 1600; 12 July 2010
Small solid squares appear in the box around the endpoints
of the first ruler line. You can drag these solid squares to re-
size the box and increase the search area; but searching more
area increases the processing time.
e. When you hover the cursor over the edge of the lines, the
lines turn red, and a message appears telling you to “Right-
click to edit.”
f. Right-click on the highlighted lines. A Rake Properties box opens. There are tabs for the
calculations available. Use the tabs and “Enable” check boxes to enable the calculations. In
this box you can: rename the measurement, change the tolerances for recycle and reject,
change the “accuracy” (number of samples to find the edge at your endpoints) and the num-
ber of lines in the rake.
Rake Properties
Avg Mean or average distance measured.
Min Minimum or shortest distance measured.
Max Maximum or longest distance measured.
Std. Dev. Standard Deviation of all measured distances, at all sample points.
• Enable – check this box to report a measurement and pass or fail the part on this measurement;
or clear this box to not report a measurement and not pass or fail the part on this measurement.
• Relative – clear the box to report actual numbers; check the box to report difference.
• Auto label position – puts the label (AvgR1) beside the tool in the display. Clear the check box
to move the label to another location (or with the Properties box closed, drag the label).