User`s manual

405-00026-00iNspect Express User’s Manual
52 Rev 1600; 12 July 2010
If the code is part of the stamp or mold that forms your part, the code should move very little, and
your rectangle can be very close to the size of the code. If the code is part of a separate label or
etching process, you need a larger rectangle to allow for variation in the location of the code.
c. When you hover the cursor over the edge of the rectangle, the rectangle turns red, and a mes-
sage appears telling you to “Right-click to edit.”
d. Right-click on the highlighted rectangle. A Properties box opens. In this box you can: re-
name the measurement, and enter a fixed code value. Use the tabs and “Enable” check boxes
to enable different measurements.
2D Barcode Properties
• Enable – check this box to report a measurement and pass or fail the part on this measurement;
or clear this box to not report a measurement and not pass or fail the part on this measurement.
• Relative – clear the box to report actual numbers; check the box to report difference.
• Value – If the code value should always be the same, type the expected value beside “Value”.
The measurements will fail if the value read does not match this value. If the code value
changes, leave an asterisk “*” in this field; the measurement will report any value read and will
only fail if unable to read any value. “?” is a single character “wild card”. “*” is a multiple
character “wild card”.