User`s manual

iNspect Express User’s Manual405-00026-00
73Rev 1600; 12 July 2010
f. Click on the padlock button to lock the value for “Perfect” so it does not change if you
move or resize the tool, or change parameters.
g. Click the “Preprocess” button
to add image filtering, or feature enhancement. Adding
preprocessing may increase inspection time. Please refer to page 15.
h. Click the “check” button
to accept changes and close the Bead Properties box. Click the
X button
to close without changes.
Using the ColorMeter Tool
The ColorMeter tool can be used to identify colors in the image, or can be used to
report the amount of a color or colors occurring in the image.
a. Click on the “ColorMeter” button. Select a Region shape. Refer to the Tip window for draw-
ing instructions.
b. Move the mouse over the image in the Work Area. Click and release the mouse button, move
the mouse and click again, to draw a Region over the area you want to measure or report on.
c. The Region is labeled (Color1%1, Color1%2, etc.) the last number is the Tool number (for
multiple ColorMeter tools). You can move and resize the Region.
d. When you hover over the ColorMeter Tool, the Region outline turns red, and a message
should appear, telling you to ”right–click to edit.”
e. Right–click on the Region outline. A ColorMeter Properties edit box opens. In this box you
can: rename the measurement, and set the tolerances for recycle and reject. Use the tabs to
enable more measurements. Use the pull–downs to define or lock the colors measured.