User`s manual

1
2
3
side A
side B
iNspect Express User’s Manual405-00026-00
75Rev 1600; 12 July 2010
• Enable – check this box to report a measurement and pass or fail the part on this measurement;
or clear this box to not report a measurement and not pass or fail the part on this measurement.
• Relative – clear the box to report actual numbers; check the box to report difference.
• Auto label position – puts the label beside the tool in the display. Clear the check box to move
the label to another location (or with the Properties box closed, drag the label).
• Locator – makes the tool follow the Locator, and follow the part. Select a locator (by number)
to follow, or select “X” to disconnect the tool from the locator, or make the tool stay in a fixed
position in the image area.
• Color1 – a drop-list assigns a Color Class (or percent area) for the “Color1%” measurement.
• Color2 – a drop-list assigns a Color Class (or percent area) for the “Color2%” measurement.
• Color3 – a drop-list assigns a Color Class (or percent area) for the “Color3%” measurement.
f.
Click on the padlock button to lock the value for “Perfect” so it does not change if you
move or resize the Region, or change parameters.
g. Click the “check” button
to accept changes and close the Properties box. Click the X
button
to close without changes.
Using the Spring Tool
The Spring tool measures periodic or repeating objects, such as a screw thread or coil
spring.
a. Click on the ”Spring” button. Draw a rectangle
(at any angle), that encloses the area of the re-
peating object. Refer to the Tip window instruc-
tions. The rectangle should be larger than the ob-
ject. Click at one end of the spring, then click at
the other end, on the same side of the spring.
Then click at the opposite side of the spring. The
first 2 clicks define ”side A” and the third click
defines ”side B”.