User`s manual

405-00026-00iNspect Express User’s Manual
78 Rev 1600; 12 July 2010
• Enable – check this box to report a measurement and pass or fail the part on this measurement;
or clear this box to not report a measurement and not pass or fail the part on this measurement.
• Relative – clear the box to report actual numbers; check the box to report difference.
• Auto label position – puts the label (WP1) beside the Region rectangle in the display. Clear the
check box to move the label to another location (or with the Properties box closed, drag the
label).
• Locator – makes the tool follow the Locator, and follow the part. Select a locator (by number)
to follow, or select “X” to disconnect the tool from the locator, or make the tool stay in a fixed
position in the image area.
• Sensitivity – a higher setting is more sensitive to edge transition that have less contrast be-
tween light and dark.
• Show – display or hide measurement lines and points in the tool display:
top “tip line” drawn through the top “tip points”.
bottom “tip line” drawn through the bottom “tip points”.
center line, centered between the tip lines.
left end point, the first detected edge along the center line.
right end point, the last detected edge along the center line.
• Min peak height – sets a minimum distance, in pixels, for measuring or rejecting tips.
• Center axis – position of the ”center axis” relative to ”side A” and ”side B” (in percent). The
spring Length is measured on the Center axis. A value of 0 places the Center axis very close to
the Tip line of side B. A value of 100 places the Center axis very close to the Tip line of side A.
h. Click on the ruler button
(Diam. tab only) to set new units (Scale) on this one measure-
ment, or on the whole coordinate system used for this camera view.
NOTE If you enter new units, and select “Coordinate System”, clicking the green
“check” in the scale properties immediately applies the changes to the whole
coordinate system; the red X button in the Spring Properties does not undo the
change to the coordinate system. Click the curved arrow button
to undo
scale changes, and revert to pixel coordinates for the whole coordinate system.
This removes Calibration.