User`s manual

iNspect Express User’s Manual405-00026-00
1Rev 1600; 12 July 2010
The iNspect Application
Creating an Inspection Solution
1.Launch iNspect Client
You need a PC that is connected to the BOA, either through a local network or by directly con-
necting through a crossover Ethernet cable. If you have not configured the PC and BOA to com-
municate please refer to the BOA Installation Manual for instructions on changing the IP Ad-
dresses to be compatible.
NOTE The first time you open the iNspect application on a PC, you get a warning mes-
sage about certificates and signatures. Click “OK”. The iNspect application is
writing its OCX and support files into your System directory. A few seconds af-
ter the hourglass disappears, the iNspect application window will open.
There are 3 ways to connect to the BOA and start iNspect Express on the client PC. , or “Connect
to BOA” does not use Internet Explorer.
• using Internet Explorer, enter the BOA address. You do not need to load the emulator software
to connect with Internet Explorer.
• using the “iDiscover” utility or “Discover BOA Cameras” in the Start menu (if the Emulator
software was installed). iDiscover launches Internet Explorer, with the address of the BOA.
• using “Connect to BOA Camera” in the Start menu (if the emulator software was installed).
a. On the PC, open Internet Explorer. Enter the IP Address of your Camera, without a www.
The factory default address is http://192.168.0.100. This may have been changed during
installation to be compatible with other equipment in your facility.
b. On the Vision System Home Page, click on “iNspect Express”.
The Vision System Home Page