User`s manual

Linea 2K, 4K, 8K and 16K Camera User's Manual PRELIMINARY 49
Teledyne DALSA 03-032-20206-01
Camera Control Feature Descriptions
The following table describes these parameters along with their view attribute and minimum camera
firmware version required. Additionally the firmware column will indicate which parameter is a
member of the DALSA Features Naming Convention (DFNC), verses the GenICam Standard Features
Naming Convention (SFNC not shown). The Device Version number represents the camera software
functional group, not a firmware revision number.
Display Name
Feature
Description
Device
Version
& View
Internal Line
Rate
AcquisitionLineRate
Specifies the camera internal line rate, in Hz
when Trigger mode set to internal.
Note that any user entered value is
automatically adjusted to a valid camera value.
1.00
Beginner
Measured Line
Rate
measureLineRate
Specifies the line rate provided to the camera by
either internal or external source (RO)
1.00
Beginner
Refresh
measured line
rate
refreshMeasureLineRate
Press to show the current line rate provided to
the camera by either internal or external sources
1.00
Beginner
Exposure Time
Source
ExposureMode
Sets the operation mode for the camera‘s
exposure (or shutter). (RO)
1.00
Beginner
Timed
Trigger Width
Timed
TriggerWidth
The exposure duration time is set using the
Exposure Time feature and the exposure starts
with a LineStart event.
Uses the width of the trigger signal pulse to
control the exposure duration.
Exposure Time
ExposureTime
Sets the exposure time (in microseconds) when
the Exposure Mode feature is set to Timed.
1.00
Beginner
Measured
Exposure Time
measureExposureTime
Specifies the exposure time provided to the
camera by either internal or external source (RO)
1.00
Beginner
Refreshed
measured
exposure time
refreshMeasureExposureTime
Press to display the current exposure time
provided to the camera.
1.00
Beginner
Gain Selector
System Gain
GainSelector
SystemGain
Selects to which line that gain will be applied
Gain will be applied to top and bottom lines
equally
1.00
Beginner
Gain
Gain
Sets the selected gain as an amplification factor
applied to the image.
1.00
Beginner
Offset
BlackLevel
Controls the black level as an absolute physical
value. This represents a DC offset applied to the
video signal, in DN (digital number) units.
1.00
Beginner