Specifications

GEVA User’s Reference405-00024-00
39Rev 02; 9 November 2010
• Sapera Network Configuration Tool. Note: Changing the Camera Name in this program may
make the camera inaccessible to the Sherlock and SaperaLT software. Advanced–Recover
Camera can be used to reset the camera IP Address to DHCP/LLA, following the display steps.
Sherlock
• Image processing library and Integrated Development Environment (IDE) with a Graphical
User Interface (GUI) used to design, test, debug, and deploy machine vision applications.
• Sherlock uses the Sapera LT library and Genie Framework drivers for image acquisition. The
“Sapera LT” driver must be enabled in the Acquisition Options. You may point to a Sapera
CamExpert camera configuration file.
• Sherlock uses the VA-Genie Setup drivers for the Industrial I/O and Camera I/O. The “IFC”
driver must be enabled in the Acquisition Options. You may point to a VA-Genie Configura-
tion file if you have made changes to the default I/O configuration; for example, disabling
strobe outputs.
Sapera Acquisition Wizard
• This Sherlock utility detects all available hardware or cameras supported under Sapera LT, and
creates a file “SaperaLTDrv.ini” that identifies the cameras by their Camera Name. You can
enable or disable camera ports, and select camera configuration files in this utility. NOTE: If
this configuration file does not match the number of cameras (if two cameras are enabled, but
one camera is later disconnected) the Sapera LT and Genie drivers will not load, and Sherlock
will not run saved programs. Sherlock will open a new “investigation” file.
iNspect
• Inspection application with Graphic User Interface (GUI) for easy setup of product inspection.
• iNspect uses the VA-Genie Setup drivers for camera acquisition. iNspect maintains its own
settings and control over the camera settings and I/O.
Acronis True Image
• GEVA systems contain a factory restore image on the hard drive. During system boot, press the
F9 key to start the Acronis software, and restore the factory settings. Any configuration
changes made after receiving your GEVA are lost.
• The Acronis software also allows you to create new system backup images. New images can-
not be stored in the recovery partition on the hard drive. You can use a USB flash drive, external
CDRW drive, or network storage.