Specifications

405-00024-00GEVA User’s Reference
40 Rev 02; 9 November 2010
APPENDIX A
CONNECTORS AND PINOUTS
This section provides the connector pinout information for each of the GEVA external interfaces.
All rear panel connections are made with Molex connectors, included with the GEVA chassis.
Camera Power and Control Connectors
Camera control signals and power are available on two 7-pin Molex connectors, located on the
rear panel. The pinout for the connectors are shown below. Color codes for the DALSA cable are
given in this table. Each cable can supply up to 500 mA at +12 Volts from chassis power, pro-
tected by a fusable link.
Camera Port Connector Pinout
7-pin
Molex
GEVA
Label
Color
Camera
Function
Direction
12-Pin
Hirose
1 TRIG White Trigger on IN2+ Camera In, GEVA Out 11
2 STRB Orange Strobe on OUT2+ Camera Out, GEVA In 7
3 CIN1 Green IN1 + Camera In, GEVA Out 6
4 COUT1 Blue OUT1 + Camera Out, GEVA In 4
5 I/O COM Brown – for all I/O 3, 5, 8, 12
6 12V Red +12 Volt Power Camera Power input 2
7 GND Black Power Ground 1
Cameras pins 3, 5, 8, 12 are connected together through the connector shell and grounded by
the brown wire to I/O COM on the Molex connector.
GEVA supplies 12 Volts at 500 mA maximum to each camera connector through a fusable
link.
Figure 20. Camera I/O Port Connectors