Specifications

405-00024-00GEVA User’s Reference
60 Rev 02; 9 November 2010
5. Click on “Setting” beside “Output Settings” in the I/O Controls” panel (Figure 35), to open
the Output Settings window (Figure 37).
The GEVA uses only Output 2. The DCI-100 supports both Output 1 and Output 2.
6. Configure the “Event Mode” and the Strobe Out delay and duration. Always use “Active
Open” in the second field (see figure) with the GEVA.
7. Click on “Output 2” at the top of this window.
8. Configure the “Event Mode” and the Strobe Out delay and duration. Always use “Active
Open” in the second field (see figure) with the GEVA.
Figure 37. Output Settings
NOTE If the Event Mode for either Output1 or Output2 is set to “Close” or “Open”
these outputs will appear in Sherlock’s “digital outputs” and change the stan-
dard output channel number assignments. If Output1 and Output2 are set to
Strobe or Pulse functions, they will not appear in Sherlock’s digital outputs.