User`s manual

Preliminary
30 • Operational Reference Genie Monochrome Series-GigE Vision Camera
Read Only Parameters
Parameter Description
Device Vendor For the Genie Monochrome series, this is always DALSA.
Device Model Name Displays the device model name (for example, Genie M640).
Device Version Displays the device version.
Firmware Version Displays the currently loaded firmware version.
Device ID Displays the camera serial number.
MAC Address Displays the unique MAC (Media Access Control) address of the Genie camera.
User Set Parameters
Parameter Description
Device User ID Specifies a user ID, of up to 15 characters, for the Genie camera. By default, this
field is set to the serial number of the camera.
Power-up Configuration
Click Setting to open the Power-up configuration dialog box which allows you to
specify camera power-up configuration. For more information, see "
Power-up
Configuration" on page 30.
Power-up Configuration
The Power-up configuration dialog allows you to specify the camera configuration to load when
powering-up the camera. The Genie camera flash memory contains two possible configuration
settings; the Factory Default, and a user-defined Camera Configuration 1. The Camera Power-up
configuration drop-down list box allows you to select either the Factory Default or a user specified
camera configuration file. To save the current CamExpert settings to the camera user-defined (Camera
Configuration) setting, click Save. To view in CamExpert a camera configuration file currently saved
in the camera, select the configuration file in the Load configuration from Camera drop-down list,
and click Load. See "
Genie Power-up Configuration" on page 66 for a list of the saved parameters.