User`s manual

Preliminary
Genie Monochrome Series-GigE Vision Camera Technical Specifications • 91
Connectors
• A single RJ45 Ethernet connector for control and video data to the host Gigabit NIC. Genie is
available with an industrial case supporting a screw lock Ethernet cable (see "
Industrial RJ45
Ethernet Cables" on page 99).
• A single 12-pin Hirose male connector for power, trigger and strobe signals. The suggested
female cable mating connector is Hirose model HR10A-10P-12S.
12-Pin Hirose Connector Signal Details
The following figure shows the pinout identification when looking at the Genie camera 12-pin male
Hirose connector. The table below the figure lists the Genie I/O signal specifications.
Pin Direction Genie Signal (see details below) Notes
1 - Power GND
2 - +12V DC power supply 10% tolerance
3 Out Output 1 -
4 Out Output 1 +
5 In Input 1 - RS422- or TTL GND
6 In Input 1 + RS422+ or TTL
7 Out Output 2 + / Strobe +
8 Out Output 2 - / Strobe -
9 - Reserved
10 - Reserved
11 In Input 2 + / Trigger + RS422+ or TTL
12 In Input 2 - / Trigger - RS422- or TTL GND
shell / shield via cable shield Genie chassis connects to supply earth ground improves EMI shielding