User`s manual

102  Technical Specifications Genie Monochrome Series-GigE Vision Camera
Connectors
 A single RJ45 Ethernet connector for control and video data to the host Gigabit NIC. Genie supports a screw
lock Ethernet cable (see "Ruggedized RJ45 Ethernet Cables" on page 112).
 A si
ngle 12-pin Hirose male connector for power, trigger and strobe signals. The suggested female cable
mating connector is Hirose model HR10A-10P-12S.
12-Pin Hirose Connector Signal Details
The following figure shows the pinout identification when looking at the Genie camera 12-pin male Hirose
connector. The table below the figure lists the Genie I/O signal specifications.
Pin Direction Genie Signal (see details below) Notes
1 - Power GND
2 - +12V DC power supply
(see Camera Performance Specifications)
3 Out Output 1 -
4 Out Output 1 +
5 In Input 1 - RS422- or TTL GND
6 In Input 1 + RS422+ or TTL
7 Out Output 2 + / Strobe +
8 Out Output 2 - / Strobe -
9 - Reserved
10 - Reserved
11 In Input 2 + RS422+ or TTL
12 In Input 2 - RS422- or TTL GND
shell / shield via cable shield Genie chassis connects to supply earth ground improves EMI & ESD shielding
(see Preventing Operational Faults
due to ESD)