User`s manual

34  Operational Reference Genie Monochrome Series-GigE Vision Camera
Camera Information via Sapera LT or GigE Vision Compliant
Applications
Sapera
Genie Sapera parameters for Camera and Sensor Information:
Interface = {GigE Vision}
DeviceVendorName = “DALSA”
DeviceModelName = “Genie M640” for Genie M640
DeviceVersion = String representing the version of the camera
FirmwareVersion = String representing the version of the camera firmware
DeviceID = String representing the camera serial number
MACAddress = String representing the camera MAC address
DeviceUserID = String representing the user-define name for the camera
DeviceMaxThroughput = Maximum throughput of image streaming in bytes/sec.
DeviceScanType = {Areascan}
ColorType = {Monochrome Sensor}
SensorWidth = Width of the sensor in pixels
SensorHeight = Height of the sensor in lines
PixelSize = Number of bits per pixel
In CamExpert, these parameters are visible under “Camera Information” and “Sensor” tabs.
See "
Accessing Features with Sapera++ LT" on page 74.
XML features for Camera and Sensor Information:
DeviceVendorName = Name of camera vendor
DeviceModelName = Name of the camera model
DeviceVersion = Displays the device version which includes the firmware release and build.
DeviceFirmwareVersion = Displays the currently loaded firmware version manufacturer's
code.
DeviceID = Displays the factory set camera serial number.
DeviceUserID = A user set ID of up to 15 characters. By default this field is set to the serial
number of the camera.
DeviceScanType = {Areascan}
DeviceMaxThroughput = Maximum number of bytes per second the device supports
DeviceRegistersStreamingStart = Announces the start of registers streaming without
immediate checking for consistency
DeviceRegistersStreamingEnd = Announces the end of registers streaming and performs
validation for registers consistency before activating them
DeviceRegistersCheck = Performs an explicit register set validation for consistency
DeviceRegistersValid = States if the current register set is valid and consistent
SensorWidth = Width of sensor (effective pixels)
SensorHeight = Height of sensor (effective pixels)
PixelSize = Number of bits per pixel (typically 8 or 10-bits per pixel)
WidthMax = Maximum image width. Depends on binning and ROI settings
HeightMax = Maximum image height. Depends on binning and ROI settings