User`s manual
78  Operational Reference  Genie Monochrome Series-GigE Vision Camera 
ImageTimeout  RW  N.conn  EXP10: 6  700000 
min=10000, max=6000000, 
inc=1 
LUTData  RW  N.conn     
(type Buffer) 
FlatFieldGainBuffer  RW  N.conn     
(type Buffer) 
FlatFieldOffsetBuffer  RW  N.conn     
(type Buffer) 
UserBuffer 
(see Accessing the Genie User Buffer) 
RW  N.acq     
(memory of type Buffer 
available to the user) 
FlatFieldGainMin  RO  N.conn  EXP10: 0  (see note 
1) 
min=0, max=16777215, inc=1 
FlatFieldGainMax RO N.conn EXP10: 0 (see note 
1) 
min=0, max=16777215, inc=1 
FlatFieldOffsetMin RO N.conn EXP10: 0 (see note 
1) 
min=0, max=16777215, inc=1 
FlatFieldOffsetMax  RO  N.conn  EXP10: 0  (see note 
1) 
min=0, max=16777215, inc=1 
FlatFieldWidth  RO  N.conn  EXP10: 0  (see note 
1) 
min=0, max=16777215, inc=1 
FlatFieldHeight RO N.conn EXP10: 0 (see note 
1) 
min=0, max=16777215, inc=1 
InputPinStatusInput_1 RO Invalid EXP10: 0 1 
min=0, max=1, inc=1 
InputPinStatusInput_2 RO Invalid EXP10: 0 1 
min=0, max=1, inc=1 
Note 1: not displayed in CamExpert; not saved in a camera configuration file (CCF) 
Feature Type BOOL 
Feature Name  Access  W-mode  Type  Value  Notes 
LUTEnable RW N.conn BOOL True/False  
TriggerEnable RW N.acq BOOL True/False  
TriggerSoftware  RW  Always  BOOL  True/False   
AcquisitionArm  WO  N.acq  BOOL  True/False  (see note 2) 
FlatFieldEnable  RW  N.conn  BOOL  True/False   
FlatFieldCalibrationEnable  RW  N.conn  BOOL  True/False  (see note 3) 
TimestampReset  WO  Always  BOOL  True/False   
SaveCameraConfiguration WO N.conn BOOL True/False   
LoadCameraConfiguration  WO  N.conn  BOOL  True/False   
Note 2: Prepares the Genie for an optimal acquisition start with minimal delay. This feature should be set true only 
after all other features are set else the effect of AcquisitionArm is canceled. 
Note 3: FlatFieldCalibrationEnable is set True before a calibration sequence is performed. When calibration is 
enabled features such as Crop, Flip, LUT, etc. are reset to their default state before the calibration sequence is 
started. The application would need to restore these features after flat field calibration is complete. 










