User`s manual

18 • Part I: PC2-CamLink Board PC2-CamLink User's Manual
• Under ‘Select Board’ choose the PC2-CamLink board (CL2 prefix) you want to map (CL20 is the
first PC2-CamLink board, CL21 is the second, …).
• Under ‘Select COM Port Number’ assign an unused COM Port number to that PC2-CamLink
board and click Set.
• Click Close.
• Reboot PC for the new settings to take effect.
Setup Example Using HyperTerminal
• Run HyperTerminal and type a name for the new connection when prompted, click OK.
• Select the COM Port you want to connect with within the following dialog screen. In this example
the PC2-CamLink serial port was previously mapped to COM3 by the IFC Serial Port
Configuration program.
• HyperTerminal opens a dialog box where the COM Port properties are configured (see screenshot
below). Adjust settings as required by the connected camera. Note that the PC2-CamLink serial
port does not support hardware flow control.