User`s manual

PC2-CamLink User's Manual Part I: PC2-CamLink Board • 69
J2: DB-15 Female Connector
Pin 1
Pin 15
Pin # Pin Name Type Description
1
Opto Trigger1+ Input The anode’s side of the first opto-coupler. It can
manage up to 25V signals or TTL signals.
Configurable through a jumper.
9
Opto Trigger1- Input The cathode side of the first opto-coupler. It can
manage up to 25V signals or TTL signals.
Configurable through a jumper. Must be grounded
when in TTL mode.
2
Opto Trigger2+ Input The anode side of the second opto-coupler. It can
manage up to 25V signals or TTL signals.
Configurable through a jumper.
10
Opto Trigger2- The cathode side of the second opto-coupler. It can
manage up to 25V signals or TTL signals.
Configurable through a jumper. Must be grounded
when in TTL mode.
4
LVDS Trigger1 + Input Positive line of first LVDS trigger signal.
11
LVDS Trigger1 - Input Negative line of first LVDS trigger signal.
5
LVDS Trigger2 + Input Positive line of second LVDS trigger signal.
12
LVDS Trigger2 - Input Negative line of second LVDS trigger signal.
6
Shaft Encoder ChA+ Input Positive line of the shaft encoder channel A LVDS
signal.
13
Shaft Encoder ChA- Input Negative line of the shaft encoder channel A LVDS
signal.
7
Shaft Encoder ChB+ Input Positive line of the shaft encoder channel B LVDS
signal.
14
Shaft Encoder ChB- Input Negative line of the shaft encoder channel B LVDS
signal.
15
Strobe Output Strobe light output.
8
12V/5V Jumper selectable camera power (1.5A maximum).
The power is provided by a floppy disk power
connector.
3
GND Ground