User`s manual

PC2-CamLink User's Manual Part I: PC2-CamLink Board • 71
19 OUT2 Digital Output pin 2 10
21 OUT4 Digital Output pin 4 11
23 OUT6 Digital Output pin 6 12
25 +5V +5V power output 13
2 STROBE_0 Strobe Output 14
4 STROBE_1 Strobe Input 15
6 I/O_INT Interrupt Input 16
8 IN0 Digital Input pin 0 17
10 IN2 Digital Input pin 2 18
12 IN4 Digital Input pin 4 19
14 IN6 Digital Input pin 6 20
16 +5V +5V power output 21
18 OUT1 Digital Output pin 1 22
20 OUT3 Digital Output pin 3 23
22 OUT5 Digital Output pin 5 24
24 OUT7 Digital Output pin 7 25
26 n/c no connection n/a
J9: Reserved
J11: Start Mode
• Default Mode: Shunt jumper is installed.
• Safe Mode: Shunt jumper is removed if any problems occurred while updating the PC2-
CamLink firmware. With the jumper off, reboot the computer and update the firmware
again. When the update is complete, install the jumper and reboot the computer once
again.