User`s manual

74 • Part I: PC2-CamLink Board PC2-CamLink User's Manual
Status: Camera Link Connector (J1)
Status: Trigger (J2)
ACQ
TRIG
Figure 24: Visual Status LEDs
There are five additional LEDs located on the PC2-CamLink. These LEDs give supplemental
information concerning the state of the voltage supply, amp overload, and Safe Mode.
J14
PC2-CamLink
LED 2
LED 3
LED 4
LED 5
LED 6
Figure 25: Visual Status of Supplemental LEDs
The table below specifies each LED and the result of its activation.
Description Result
LED2
1.5A Overload Too much current drawn by the camera from the floppy connector.
LED3
Host 12V Overload Too much current drawn by the camera from the PCI connector . Connect
power floppy cable.
LED4
Safe Safe mode ON.
LED5
5V PCI 5 volts PCI bus detected.
LED6
3.3V PCI 3.3 volts PCI bus detected.