User`s manual

Piranha4 4K and 2K Dual Line Monochrome CMOS Camera User's Manual 63
Teledyne DALSA 03-032-20176-02
The following table describes the digital I / O control parameters along with their view attributes and the
minimum camera firmware version required. Additionally, the firmware column indicates which
parameter is a member of the DALSA Features Naming Convention (DFNC), verses the GenICam
Standard Features Naming Convention (SFNC not shown). The Device Version number represents the
camera software functional group, not a firmware revision number.
Display Name
Feature
Description
Device
Version
& View
Trigger Source
Trigger Source
Defines the source of external trigger (RO)
1.00
DFNC
Beginne
r
Trigger
Selector
Trigger Selector
Defines what the trigger initiates (RO)
1.00
DFNC
Beginne
r
Trigger Mode
Trigger Mode
Determines the source of trigger to the camera, internal
or external (CC1)
1.00
DFNC
Beginne
r
Flat Field Category
The P4 Flat Field controls, as shown by CamExpert, group parameters used to configure camera pixel
format, and image cropping. Additionally a feature control to select and output an internal test image
simplifies the process of setting up a camera without a lens.
Parameters in gray are read only, either always or due to another parameter being disabled. Parameters
in black are user set in CamExpert or programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or third
party software usage—not typically needed by end user applications.