User`s manual

Spyder 3 GigE User’s Manual
DALSA 03-032-10158-09
93
Background Subtract: 0 0
Background subtract
settings set with the
135Hssb command. See
section
316HA2.2 Analog
and Digital Signal
Processing Chain for
details.
System Gain (DN): 4096 4096
Digital gain settings set
with the
136Hssg command.
See section
317HA2.2 Analog
and Digital Signal
Processing Chain for
details.
GPIO Configuration
S
ignal Mode
I
nput0 Disabled
I
nput1 Disabled
I
nput2 Disabled
I
nput3 Disabled
O
utput0 High Impedance
Output1
H
igh Impedance
O
utput2 High Impedance
Output3 High Impedance
Current GPIO pinout
configuration. Refer to
section
318HA1.5
Configuring the GPIO
Connector for details.
Returning Camera Settings with Get Commands
You can also return individual camera settings by inserting a “get” in front of the
command that you want to query. If the command has a tap or pixel number parameter,
you must also insert the tap number or pixel number that you want to query. Refer to
319HTable 13 below for a list of available commands. To view a help screen listing the
following get commands, use the command
gh.
Table 13: Get Commands
Syntax Parameters Description
get cao
t
Returns the analog offset for the tap indicated
t = tap selection, either 1 to 2 depending on camera
model, or
0 for all taps
get ccf
x1 x2
Returns the FPN pixel coefficients for the pixel range
indicated.
x1 = Pixel start number
x2= Pixel end number
get ccp
x1 x2
Returns the PRNU pixel coefficients for the pixel range
indicated.
x1 = Pixel start number
x2= Pixel end number
get css
Returns the number of line samples averaged for pixel
coefficient calculations or for output of
gla command.
get dgc
Returns the current GPIO configuration.
get dpc
x1 x2
Returns pixel coefficients without formatting.
get els
Returns whether the end-of-line statistics are turned off or
on.
0: Off
1: On