User`s manual

Spyder 3 GigE User’s Manual
DALSA 03-032-10158-09
95
Syntax Parameters Description
get scd
Returns the ccd shift direction where:
0 = Forward CCD shift direction.
1 = Reverse CCD shift direction.
2 = External direction control via CC3.
When
scd 2 is selected, the following is returned:
2 = External direction control: currently forward (CC3 is
high).
3 = External direction control: currently reversed (CC3 is
low).
get sdm
Returns the current camera configuration where:
0 = 8 bits, 1 tap, 40MHz data rate
1 = 12 bits, 1 tap, 40MHz data rate
2 = 8 bits, 2 taps, 80Mhz data rate
3 = 12 bits, 2 taps, 80MHz data rate
get sdo
t
Returns the digital offset value in DN for the tap
indicated.
t = Tap value. 0 for all taps or 1 to 2 for individual tap
selection.
get sem
Returns the current exposure mode:
2 = Internal SYNC, internal PRIN, programmable line
rate and exposure time using commands
ssf and set
3 = External SYNC, internal PRIN, maximum exposure
time
4 = Smart EXSYNC
5 = External SYNC and PRIN
6 = External SYNC, internal PRIN, programmable
exposure time
7 = Internal programmable SYNC, maximum exposure
time. Factory setting.
8 = Internal SYNC, internal PRIN, programmable
exposure time. Maximum line rate for exposure time.
get set
Returns the current exposure time in µs.
get sfc
x
Returns the FPN coefficient for the pixel number idicated.
x =pixel number within the range 1 to sensor pixel
count
.
get sgi
i
Returns the current input signal setting for the input
number specified where:
0 = disabled
1 = TTL
2 = LVDS
get sgo
i
Returns the current output signal setting for the output
number specified where:
0 = disabled
1 = TTL
2 = LVDS
get slt
Returns the current lower threshold value.