User`s manual

6M3P Camera User’s Manual 12
DALSA 03-32-10005-02
2.4 Power Input
Table 5: Power Connector Pinout
Pin Symbol
1 +5V
The camera has the following input
power requirements.
2+5V
3 - 5V
4+15V
V
(DC)
r%
Max
Ripple
mV
A
5 NC +15 0.5 < 5 0.45
6 NC +5 0.5 < 5 1.4
7 GND -5 0.5 < 5 0.25
8GND
9 +5V
10 - 5V
11 +15V
12 NC
13 NC
14 GND
15 GND
1
9
15
8
DB15M
(AMP Part # 747236-4
or equivalent)
Note: Performance specifications are not
guaranteed if your power supply does not
meet these requirements.
DALSA offers a linear power supply
(with cables) that meets the 6M3P’s
requirements (Universal Power Supply,
part number 24-00001-02, contact DALSA
for more information), but it should not
be considered the only choice. Many high
quality supplies are available from other
vendors. DALSA assumes no
responsibility for the use of these
supplies.
When setting up the camera’s power supplies, follow these guidelines:
x Do not connect or disconnect cable while power is on.
x Do not use the shield on a multi-conductor cable for ground.
x Keep leads as short as possible to reduce voltage drop.
x Use high-quality linear supplies to minimize noise.
!
WARNING: It is
extremely important that you
apply the appropriate
voltages to your camera.
Incorrect voltages will
damage the camera.