User`s manual

6M3P Camera User’s Manual 31
DALSA 03-32-10005-02
Write Frame Rate LS
Byte
Write Frame Rate
Center Byte
Write Frame Rate MS
Byte
Command Value Command Value Command Value
Binary 1000 1101 1000 0000 1000 1110 0001 1010 1000 1111 0000 0110
Hex 8Dh 80h 8Eh 1Ah 8Fh 06h
External Trigger/Programmed Integration
This is the same as External Integrate/SMA Trigger Mode. Reference to section 3.10
Controlling Integration Mode.
([DPSOH6HWWKH)UDPH5DWHWRISV
1. Reference section 3.9 Triggering, Integration, and Frame Rate Overview to ensure
the desired frame rate can be supported for the selected binning and integration
modes.
2. Using the command 82h, set bit [7] of the data byte to 0 (Integration Mode =
Internal) and bit [3] of the data byte to 1 (Trigger Mode = External).
NOTE: All bits within the register are written at one time. Ensure the correct value
for all bits are used when changing camera modes.
3. Set the desired integration time per section 3.10 – Controlling Integration.
4. Each TTL rising edge on the SMA connector will initiate a new frame of data,
using the programmed integration time. To achieve 2.5 fps, a TTL pulse must be
sent to the camera every 400 ms (1/2.5).
External Trigger/Serial Connector
This is the same as External Integrate/External Trigger Mode. Refer to section 3.10
Controlling Integration Mode.