Installation Guide

Prologue Delicate Gray Mosaic & Superior White
12 in. x 18 in. tiles shown in grid and brick pattern
Installation of
COUNTERTOP
& WALL TILE
INSTALLATION INSTRUCTIONS | COUNTERTOP & WALL TILE | PAGE 4 of 5
• Using the instructions on the
package, make enough grout to
use in about 30 minutes.
• Remove tile spacers and spread
grout on the tile surface, forcing
down into joints with a rubber
grout float or squeegee.
• Tilt the float at a 45° angle and remove
excess grout from surface immediately
with the edge of float.
• Tilt it at a 90° angle and scrape it
diagonally across tiles.
• Wait 15–20 minutes for grout to set
slightly, then use a damp sponge to clean
grout residue from surface and smooth
the grout joints, rinsing sponge often.
• Let dry until grout is hard and haze
forms on tile surface, then polish
with a soft cloth and wait 72 hours
for heavy use. NOTE: Don’t apply
sealers or polishes for three weeks,
and then only in accordance with
manufacturer’s recommendations.
STEP 7: GROUTING JOINTS
7
STEP 8: INITIAL CLEANING
8
• The complete removal of
grout and construction dirt
after products have been
installed will improve daily
maintenance.
• Clean successfully by
scrubbing the installation
with hot water and a pH
neutral liquid cleaner
(soapless), followed by a
thorough rinsing, then remove
the rinse water with a wet
vacuum or dry toweling.
• If some residue remains,
further cleaning will need to
be done in consultation with
the grout manufacturer.
• For more aggressive
cleaning, scrubbing machines
equipped with nylon pads
or brushes should be used.
Wet vacuuming of the
suspended dirt and grout is
recommended.