Installation Guide

Photo features Rapport™
Panda Marble 12 in. x 24 in. Floor & Wall Tile
Installation of
FLOOR & LARGE
FORMAT TILE
INSTALLATION INSTRUCTIONS | FLOOR & LARGE FORMAT TILE | PAGE 4 OF 5
STEP 7: CLEANING
7
• A thorough cleaning is recommended
after the installation is complete to
remove all grout residue and
construction dirt from the surface.
• Start out by scrubbing the surface of
the tile with hot water and a pH neutral
liquid cleaner (soapless).
• After scrubbing, make sure to rinse the
tile thoroughly with water and remove
the excess water with a wet vacuum or a
dry towel.
• If any additional residue remains on the
surface of the tile, you can consult with
the grout manufacturer to take further
action.
NOTE: If a more aggressive cleaning
approach is needed, you can use a oor
scrubbing machine equipped with nylon
pads or brushes.
CONTINUED ON NEXT PAGE
STEP 6: GROUTING JOINTS
6
• Following the instructions on the
packaging, make just enough grout to
last you for approximately 30 minutes.
• Remove the spacers and begin
spreading the grout across the tile
surface, forcing it down into the joints
with a rubber grout oat or squeegee.
• Tilt the oat at a 45º angle and
move the edge along the surface of the
tile to remove any excess grout.
• After waiting 15-20 minutes for the grout
to set, use a damp sponge to clean the
residue from the surface of the tile.
• After the tile has set long enough for the
grout to harden and a haze to form on
the top of the tile, use a soft cloth to
remove the haze. Wait 72 hours for heavy
use.
NOTE: Make sure to wait three weeks
before applying sealers or polishes. If
you do intend to use a sealer or polish,
please reference the manufacturer’s
application recommendations.