Use and Care Manual

Prologue Delicate Gray Mosaic tile shown in grid pattern
and Superior White 12 in. x 18 in. tile shown in brick pattern
Dal-Tile Corporation
TILE CARE &
MAINTENANCE
CARE & MAINTENANCE GUIDE PAGE 6 OF 6
MOSAIC GLASS AND MIXED MATERIALS
General Cleaning
Tile, whether glazed ceramic or porcelain, should be
maintained on a regular and frequent basis to prevent
build-up of soil, grease, residue, soap detergents,
sealers, dampness, liquids, etc., to keep the surface
clean and lessen slippery conditions.
Glazed ceramic and porcelain tiles require minimal
maintenance. Either can be cleaned with clear water
and/or a pH neutral liquid cleaner (soapless). Follow
with a clear water rinse and wipe dry to prevent film
formation. As with most porcelains, spilled liquids may
stain light-colored products if not promptly removed.
Neither sealing nor acid cleaning is recommended for
any of Daltile’s glazed ceramic or porcelain tile.
Glass Tile
Use a glass cleaner and a soft lint-free cloth for
cleaning glass tile. To remove soap scum or water
deposits a minimally abrasive cleanser and soft
bristle brush can be used.
STONE MOSAIC
Routine Care
Natural Stone products are porous by nature and
many of the cleaners acceptable for use on ceramic
tile can stain, damage or dull stone.
Dirt and dust will scratch the surface of stone.
Natural Stone should be cleaned with neutral cleaners
and should never contain acid or bleach. Acids, even
a light solution of vinegar and water, will etch and
eventually damage Natural Stone.
Stone Cleaners
Only use cleaners specifically designed for cleaning
stone. These cleaners contain no acids and are
concentrated neutral pH cleaners that will not aect
existing sealers or wax-type coatings. The surface
of the stone should be dampened with clear water.
This will keep the cleaning solution on the surface
so it can be eective. A solution of the cleaner and
water mixed to manufacturer’s instructions should be
applied to the stone surface with a sponge or mop.
On walls, kitchen counters or vanity tops, a spray bottle
can be used to apply the cleaning solution. Allow sitting
for manufacturer’s specified amount of time (usually
3 to 5 minutes). Agitate with a sponge, synthetic mop,
soft bristle brush or through the use of a floor scrubbing
machine. Mop up dirty solution and bu dry.
Once the stone has been cleaned, you can periodically
apply a spray-bu wax-type floor finish to enhance
the beauty and luster of polished stone. Apply the
finish with a spray applicator and bu immediately
with a white nylon pad.
Pre-Grout Sealing
A non-sanded grout is strongly recommended for
Natural Stone installations due to the narrow grout
joints customarily preferred. All travertine, slate,
tumbled stone and honed/flamed/unpolished granite
should be sealed prior to the grouting process to
protect them from staining. The application of a good
quality sealer should be used as a grout sealer and
applied again as the final sealing process once the
installation is finished.
Metal Tile
To clean, use a liquid non-abrasive household cleaner.
DO NOT use scouring pads, steel wool, sandpaper or
other abrasive products. Avoid cleaners containing
ammonia, bleach, abrasives, or other hazardous/
polluting compounds. Always test in a small
inconspicuous area while using a new cleaner to
ensure compatibility.