User's Manual

Doc. No.
Rev.
Date
DRAFT
1.01
2012-01-27
Damm Cellular Systems A/S, Denmark
TetraFlex
®
7.5 Manual - BS421 Configuration
TetraFlex® 7.5 Manual 2-60
Figure 2-11: Change MAC
2.6 BS421 CONFIGURATION
2.6.1 Ethernet Connection
The BS421 supports 1 x 10/100 Mb/s. Ethernet connection and 1 x Ethernet type DC
connection for timing.
The purpose of the connections is
o To establish SB421 connection for control of the base station
o To establish connection to another BS421 for timing and synchronization. (1 sec
Pulse).
The Ethernet connections are limited to SELV (Safety Extra Low Voltage) connections.
The Ethernet connection shall be connected directly to the SB421 TR connection board.
The DC timing connection is connected through the SB421 LAN cable. Arresting units are an
integrated part of the SB421.
.
2.6.1.1 Set-up of IP address
2.6.1.1.1 DHCP (Typical TetraFlex
®
single node)
The IP address and the net mask is setup by means of DHCP.
When the system is delivered from DAMM, the BSC and the BS421 are paired and should
start-up without any need of configuration change.