User's Manual

Doc. No.
Rev.
Date
DRAFT
1.01
2012-01-27
Damm Cellular Systems A/S, Denmark
TetraFlex
®
7.5 Manual - Voice Gateway
TetraFlex® 7.5 Manual 2-110
 The SIP registration name (Alias) must be unique and can only be generated by the
BSC_GUI or OM command “S73/NAME/<SIP registration name>”. e.g.
“S73/NAME/TETRA-16024-2”. The name must be entered as the SIP Alias name
into the PABX as well SIP registration name and password cannot be generated by
NM, only by BSC-GUI or OM commands.
 The SIP registration password is optional and can only be generated by BSC-GUI or
the OM command “S73/PASSWORD/<password>”. e.g. “S73/PASSWORD/TETRA”
(blank means no password). The password must be entered into the PABX as well.
 The Voice GW must be assigned to a node number to attach. This can be setup in
the subscriber register in the different profiles where PABX access is desired or by
using the TetraOM command S21/”Profile No”/VGNODE/”x”/”Node Number”, where
x is 1 for primary GW and x is 2 for alternate GW.
 Organization – can be set to allow all or some organization to make call to trough the
Voice GW.
○ All – all organizations are allowed
○ If you specifies an organization ex. 1 only this is allowed
○ B- number prefix, The Org. number for the subscriber is set in front of
the dialing number so that the PABX can route this according the org.
number.
 SIP registration must be set to YES, use NM, BSC-GUI or TetraOM command
S73/REG/+
 Remote IP address is the IP of the Voice GW (e.g. IP800). Use NM, BSC-GUI or
TetraOM command S73/IPADDR/xxx.xxx.xxx.xxx
 Voice GW must be activated. Use NM, BSC-GUI or TetraOM command
S73/CNFG/+
 The SIP registration name and password (if used) must be unique and entered into
the Voice GW as well
 Use SIP registration must be set to YES.
 Remote IP address is the IP of the Voice GW (e.g. IP800)