User's Manual

Doc. No.
Rev.
Date
1.00
2011-12-08
Damm Cellular Systems A/S, Denmark
TETRAFLEX
®
V7.5 MANUAL - Network Management
TetraFlex® 7.5 Manual 3-20
3.3.4.6.3 Config
Right mouse click on the following items allows the change of the configurations.
o Description
○ Node description, E.g. In the format
○ “System-Node number-Placement” This description is collected and saved
in the CnfgMain.txt file. This can also be changed via the BSC-GUI.
o MCC
○ Mobile Country Code. Please use the appropriate code for the country
where the system is to be installed (saved in CnfgBss.txt)
o MNC
○ Mobile Network Code
○ NOTE: In certain countries this code must be supplied by the appropriate
authorities (saved in CnfgBss.txt)
o GPS
○ If set to “Yes”, the position shown on the map is set by the GPS receiver
○ If set to “No” Manual definition of the position is possible (saved in
CnfgMain.txt)
o Latitude
○ Manual definition of the position latitude (saved in CnfgMain.txt)
o Longitude
○ Manual definition of the position longitude (saved in CnfgMain.txt)
o IP address Segment
○ The IP address segment used by the Packet Data Gateway to assign an IP
to the PC attached to the terminals (saved in CnfgBss.txt)
o Timeout
○ The maximum time a call setup takes using the longest delay in the system.
○ Used to extend the node timeout: E.g. when using satellite connections with
long delays (saved in CnfgBss.txt).
o Voice
○ Initial Voice Buffer Length (Voice Frames) – This field is to avoid jitter e.g.
when using End to End encryption adds prox. 60 ms delay pr. Voice frame
added (default factory setting is 2).