User's Manual

Doc. No.
Rev.
Date
1.00
2011-12-08
Damm Cellular Systems A/S, Denmark
TETRAFLEX
®
V7.5 MANUAL - Network Management
TetraFlex® 7.5 Manual 3-29
To configure a Voice Gateway, use the NM application or use the TetraOM as described here
(SIP registration name and password can only be set by OM commands):
 The SIP registration name (Alias) must be unique and can be generated by the OM
command “S73/NAME/<SIP registration name>”. e.g. “S73/NAME/TETRA-16001-
1”. You can also set registration name with the BSCGui-BSS VoiceGW The name
must be entered as the SIP Alias name into the PABX as well.
 The SIP registration password is optional and can be generated by the OM
command “S73/PASSWORD/<password>”. e.g. “S73/NAME/” (blank means no
password). You can also set the Password with the BSCGui BSS VoiceGW. The
password must be entered into the PABX as well.
 The Voice GW must be assigned a node number to attach to. This can be setup in
NM - Subscriber register in the various profiles where PABX access is wanted or by
using the TetraOM command S21/”Profile No”/VGNODE/”x”/”Node Number”
Where x is 1 for primary GW and x is 2 for alternate GW.
 SIP registration must be set to YES, use NM or TetraOM command S73/REG/+
 Remote IP address is the IP of the Voice GW (e.g. IP800). Use NM or TetraOM
command S73/IPADDR/xxx.xxx.xxx.xxx
 Voice GW must be activated. Use NM or TetraOM command 73/CNFG/+
 Organization – can be set to allow all or some organization to make call to trough the
Voice GW.
○ All – all organizations are allowed
○ If you specifies an organization ex. 1 only this is allowed
○ B- number prefix, The Org. number for the subscriber is set in front of
the dialing number so that the PABX can route this according the org.
number.