User's Manual

Doc. No.
Rev.
Date
DRAFT
1.01
2012-01-27
Damm Cellular Systems A/S, Denmark
TetraFlex
®
7.5 Manual - Packet Data Gateway
TetraFlex® 7.5 Manual 2-116
To configure the Packet Data gateway use the Network Management program (NM), BSC-
GUI or the TetraOM application (OM)
NOTE: Packet Data GW configuration is only needed for Packet Data access from TetraFlex
to the public world. PD access Tetra to Tetra is always available and need no configuration.
o BSC-GUI:
Right mouse click on the following items allows change of the configurations.
 Configured: Yes or No is PD GW active
 RIPv2: If Yes RIPv2 is used – If No Static routing is used.
 Active mobiles count: Numbers of active mobile connections
o TetraOM:
 Activate the packet data gateway using S74/CNFG/+.
 S74/RIP/+ Activated RIP
o Network Management
These parameters can also be set from NM please see chapter 3 Network Manager
 Use the OM command S71/SUBIPADD/”IP address range”/”MASK” to configure
an IP address range defined by the MASK.
 Configure the packet data gateway Node using the OM command S21/”Profile
number”/PGNODE/x/”Node Number”. Where x is 1 for primary GW and x is 2 for
alternate GW
The following is information only
o Status
The drop down box “All Nodes” / “Active GWs” changes between display of active nodes
only, or both active and not active nodes