User's Manual

Doc. No.
Rev.
Date
DRAFT
1.01
2012-01-27
Damm Cellular Systems A/S, Denmark
TetraFlex
®
7.5 Manual - TetraOM
TetraFlex® 7.5 Manual 2-134
Then the units can then be addressed according to this scheme:
AU+ Activate HDLC bus (TR412 only, not TR421)
AU/FORCED If the HDLC connection is used by someone else
A11…18 Select TR 1 to TR 8 in rack 1
A21… 28 Select TR 1 to TR 8 in rack 2
AP11…17 Select PS1 to PS7 in rack 1
AP21… 27 Select PS 1 to PS7 in rack 2
AT11…AT12 Select combiner 1 or 2 in rack 1
AT21…AT22 Select combiner 1 or 2 in rack 2
2.14.3.1.1 Functional Description
All test commands for the Transceiver, Power Supply and the Combiner (only in BS41x)
consist of a 2-digit command in the range 00 to 99 with an optional parameter. Commands
without parameters are display-only commands and will not make any changes. Therefore, it
is possible to "page through" the commands to find the right one without any risk to change
vital parameters.
The commands are divided into groups, covering the different functions in the TR. For
example, all the TR commands are in the 10 to 19 group. If the first two characters are not
representing a valid number in the 00 to 99 range, an error message will be displayed:
Invalid TR412 command
This is however not the case if the first character is a +, which are reserved for commands to
the test box. In this case no response will be sent. If an unimplemented TR command is
called, the following response is displayed:
Unimplemented command
2.14.3.1.2 Commands
OM commands organization:
M xx - Main BSC OM Commands
F xx - Base Station Controller (BSC) OM Commands
S xx - Base Station Switch (BSS) OM Commands
H xx - Base Station (BS) OM Commands (only for BS41x)
xx - OM Commands without a letter in front is used for TR, PS or TCC
2.14.3.1.3 Running commands