User's Manual

Doc. No.
Rev.
Date
DRAFT
1.01
2012-01-27
Damm Cellular Systems A/S, Denmark
TetraFlex
®
7.5 Manual - TetraOM
TetraFlex® 7.5 Manual 2-136
2.14.3.3 Configuration
Many calibration and system parameters are stored locally in a sector of the Flash chip. At
power-up and reset, all settings are copied into the workspace RAM, from where the different
software tasks take the settings.
Any change in the configuration is only made in the workspace RAM. To store the new
configuration locally, a save command shall be made. The configuration is divided into two
separate entities:
o System configuration
o Factory configuration (only to be done by DAMM)
System configuration parameters can be changed with the 7x OM commands and are
automatically saved.
2.14.3.4 TetraOM set up
More possibilities exists “how to start the TetraOM program”:
o Start via the NM
o Start via BSC-GUI
o Start the TetraOM program from the start menu or the taskbar
o Start the TetraOM program on the BS421 directly using the VNC program.
The TetraOM program files are located on the BSC in the directory C:\Tetra\Active\Pgm\Om.
It is possible to copy all files to a similar directory on your own PC and create a shortcut to
the TetraOM.exe file for start-up. The PC must be on the same LAN as your nodes to
connect to them with OM.
After starting the TetraOM program, the connection window is shown: